Article

Can I Connect A Router Without a Computer

Can I Connect A Router Without a Computer

Each of us was faced with a situation when you need to connect a router in the apartment. For this, they usually call a specialist. We offer instructions on how to connect the router yourself.

1. Connect the wires

Insert the Internet cable into the WAN (or Internet) port of the router (router).

Then connect the router to the computer: one end of the cable to the LAN port of the router, and the other end to the PC network card connector. Instead of a cable, you can use a wireless connection, but it’s better not to do this at the setup stage.

Plug the router into a power outlet. If it also has a power button, then click on it. Wait a few minutes for the router to boot.

2. Check the Internet

If your router is already configured by the provider or received the settings automatically, then the Internet can earn a few seconds after connecting the router to the PC.

To check this, launch a browser and open several sites. If they load without problems, you can skip the fourth paragraph.

3. Router settings menu

In the address bar of the browser, type 192.168.1.1 or 192.168.0.1 and press Enter. One of these IP addresses will send to the router settings menu. If both options do not work, find the desired IP address in the documentation for your router model and try entering it.

When the login page for the settings pops up in the browser window, the system may ask for a username and password. Most often, during the first connection, one word is suitable for both fields. admin. Sometimes, for a standard password, router manufacturers use a combination of 1234.

You can also find information to enter the instructions for the router or on the provider’s website.

4. Set up your internet connection

If the Internet does not work, the router needs special settings. What specific parameters you need depends on the device model and the Internet service provider. Unfortunately, there is no universal configuration. For instructions, check the provider’s website or ask for support.

When you get the setup guide for your model, follow all the steps. If you set up an Internet connection and a home Wi-Fi network, you can proceed to the next. fifth point.

5. Set up your home Wi-Fi network

Choose the right security settings to protect your Wi-Fi network.

In the settings menu, select the section that is responsible for the wireless network (see the documentation for your router model). Enter a strong password here (it will be suitable for connecting your devices to the router via Wi-Fi) and select WPA2-PSK as a security tool.

Save the changes to the settings.

6. Change the password to enter the router settings

Just in case, it is worth restricting the access of outsiders to the router settings menu. If the router is protected by a standard password, replace it with your own.

Find the settings section that is responsible for the security (see the documentation for your router model) of the device, and enter a new strong password. Save the changes.

If your computer has a Wi-Fi module, after completing the setup, you can remove the network cable from the PC and connect to the router wirelessly.

7. Optimal router location

Best of all, if the router is located in the center of the zone in which you use Wi-Fi. Thus, the signal will be equally accessible to all connected devices.

TURBION.NET 2021